GUI issues.

[Bas ON5HB]

Steven,

Can you switch USB / LSB to LSB / USB please?
As I constantly press the wrong button.

And freq-typing and showing, you say it's MHz, but typical it's typed in KHz, not MHz.
And it Hz it should be 3630000h(z) but default to k(hz), if needed 3.630m(hz)
H or M should also be accepted as well as just h / m or mhz etc.

A transceiver at 3.63MHz would show: 3.630.000Hz in the display.

What you are showing makes no sense

[magicint1337]

Steven,

Can you switch USB / LSB to LSB / USB please?
As I constantly press the wrong button.

And freq-typing and showing, you say it's MHz, but typical it's typed in KHz, not MHz.
And it Hz it should be 3630000h(z) but default to k(hz), if needed 3.630m(hz)
H or M should also be accepted as well as just h / m or mhz etc.

A transceiver at 3.63MHz would show: 3.630.000Hz in the display.

What you are showing makes no sense

Thanks Bas.
I noted this for the 0.1.3:
LSB/USB and CW-L/CW swapped, the display says Hz instead of MHz, and "h" works when typing (3630 = kHz, 3.63 = MHz already worked)

[Bas ON5HB]

Thanks Bas.
I noted this for the 0.1.3:
LSB/USB and CW-L/CW swapped, the display says Hz instead of MHz, and "h" works when typing (3630 = kHz, 3.63 = MHz already worked)

Well yes an no, it sort of a hit and miss.

Better make it consistent in KHz, as people are used to type freq's in KHz, and let them use H(ertz) and M(Hz) when token is added, without always KHz.

As for CW, I'm not an expert in that mode, so I do not know what CW-L is. My TS-890 has only CW and CW-R whatever that means